Obtain all remote transmitters for this vehicle
1. Start with the key out of the ignition, drivers door is
open, all other doors and trunk closed and drivers door is unlocked.
2. Perform these steps within 5 seconds. A. Insert the key
into the ignition (Do NOT Turn it) and Pull key out. B. Insert the key into the
ignition (Do NOT Turn it) and Pull key out.
3. Perform these steps within 40 seconds. A. Close then open
the drivers door. B. Close then open the drivers door. C. Insert the key into
the ignition (Do NOT Turn it) and Pull key out.
4. Perform these steps within 40 seconds. A. Close then open
the drivers door. B. Close then open the drivers door. C. Insert the key into
ignition and leave it in the ignition. D. Close the drivers door. E. Turn the
ignition to ON (Do NOT Start or crank engine) then back to OFF. F. Remove the
key from the ignition.
5. Within 3 seconds, the power door locks should lock then
unlock automatically indicating successful entry into programming mode. Return
to step 1 if the door locks do not cycle at this point.
6. Perform these steps within 40 seconds. A. Press the lock
and unlock buttons on the remote simultaneously for 1.5 seconds. B. Immediately
after letting go of the lock and unlock buttons, Press the lock button by
itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and
then unlock once indicating successful programming. If the door locks cycle
twice, repeat steps A and B in step 6 as the remote was not accepted. C. Repeat
steps A and B in step 6 for each new remote.
7. Open drivers door.
KEY FOB 
