Home > Dodge > Ram 2500 > 2008

2008 Dodge Ram 2500 Key Fobs

Sort By:
Page of 1
   
 
Programming Instructions

2008 Dodge Ram 2500 Key Fob Programming Instructions

Obtain all remote transmitters for this vehicle.


THIS PROCEDURE IS FOR FOBIX REMOTES:
YOU MUST HAVE TWO WORKING FOBIX REMOTES TO USE THIS PROCEDURE

1. Insert first programmed key into ignition switch.

2. Switch ignition ON for at least 3 seconds but no longer than 15 seconds.

3. Turn ignition OFF and remove key.

4. Within 15 seconds insert second programmed key into ignition switch and turn ignition ON.

5. After 10 seconds an audible tone will be heard and immobilizer warning lamp will flash.

6. Turn ignition OFF and remove second programmed key.

7. Within 60 seconds insert non-programmed key into ignition switch and turn ignition ON.

8. After 10 seconds an audible tone will be heard and immobilizer warning lamp will illuminate for 3 seconds.

9. Switch ignition OFF.

10. Remove key.

11. Check operation of programmed key transmitter.

12. Repeat procedure for additional key transmitters if required (up to 8 key transmitters can be programmed).