Home > Oldsmobile > Aurora > 1996 >

NEW Keyless Entry Key Fob Remote For a 1996 Oldsmobile Aurora 4 Buttons
New Key Fob Remote For a 1996 Oldsmobile Aurora w/ 4 Buttons & Programming
 
Alternative Views:


List Price: $99.95
Our Price: $24.77
Savings: $75.18
FCCID: 25678792 , 25668603 , 25628814
Battery Size CR2032
Note: Batteries sold separately

Quantity in Stock:(Out of Stock)


Availability:: In Stock
Product Code: 1996-OLDS-AURORA-BUT4B-FOB
Qty:

 
 
THIS IS A BRAND NEW REMOTE.  ALL OF OUR ITEMS HAVE BEEN TESTED AND WE OFFER A 100% MONEY BACK GUARANTEE, SO PURCHASE WITH CONFIDENCE AND NO RISK!

VEHICLE:  1996 OLDSMOBILE AURORA    
PROGRAMMING INSTRUCTIONS:  GOOD NEWS!  THIS REMOTE IS SELF-PROGRAMMABLE, NO PROFESSIONAL NEEDED.  PLEASE SEE BELOW FOR COMPLETE PROGRAMMING INSTRUCTIONS.  
KEY FOB INCLUDES NEW BATTERY
WE HAVE PHONE SUPPORT:  402-964-2720
  • Please also note you will need to program the remote to your vehicle, the remote will not just show up and work.  
  • We ship United State Postal Service First Class mail and have items shipped within 1 business day. Please email with questions. 100% Money Back Guarantee!
  •   
  • We strive to keep our 100% POSITIVE FEEDBACK, so whatever we can do to help just let us know.

  • Visit our Ebay Store For All Your Key Fob Remote Needs: 

     http://stores.ebay.com/keyfobmall


PROGRAMMING INSTRUCTIONS FOR A 1996 OLDSMOBILE AURORA

Obtain all remote transmitters for this vehicle.

     
    dlc-port-1-16.jpg

     

    1. Locate the Data Link Port. It is located under drivers side dash. You may need to lay on the floor and look up under the dash to see it. Be sure you know which ports are 8 and 4. Notice the port is wider on the top row. If you are looking at the port with the wide row on top and the narrow row on bottom, Port 1 will be in the upper left corner and port 8 in the upper right corner. Be sure there are metal pins inside ports 8 and 4. Please refer to the diagram above to locate the proper pins. The numbers are not on the connector, they are only for reference.

    2. Connect pin 8 to pin 4 with a suitable jumper wire. Any short piece of wire will work fine. A paper clip bent in the shape of a U will work perfect. (leave the jumper wire connected throughout the programming procedure).

    3. Insert key into the ignition and turn the ignition cylinder to the ON position. The vehicle will respond by locking and unlocking the doors to indicate vehicle has entered programming mode.

    4. Press and hold both the LOCK and UNLOCK buttons together on the first remote to be programmed. After about 15 seconds, the vehicle will respond by locking and unlocking the doors. Release the buttons on the remote.

    5. Within one minute, repeat step 4 on all additional remotes including working ones to be programmed.

    6. Remove the jumper wire connected to the Data Link Port.
 



Share your knowledge of this product. Be the first to write a review »