These instructions are for the Remote portion only. Using these programming instructions will not allow your key to start your vehicle only Lock, Unlock, and open trunk.
Key portion must be cut and programmed by a professional locksmith or the dealership.
Obtain
all remote transmitters for this vehicle.
1.
Start with key out of the ignition, open and unlock driver�s door and be sure
all other doors and trunk are closed.
2. Insert key into ignition (Do not turn) and pull it out.
3. Perform these steps within 40 seconds.
A.
Using the power door lock rocker switch on driver�s door perform 5 lock/unlock
cycles starting with lock. Use an even pace and try to go about one cycle per
second. (1 cycle = 1 lock and 1 unlock.).
4. Close, then open driver�s door.
5. Perform these steps within 40 seconds.
A.
Using the power door lock rocker switch on driver�s door perform 5 lock/unlock
cycles starting with lock. Use an even pace and try to go about one cycle per
second. (1 cycle = 1 lock and 1 unlock.)
B.
Insert the key in the ignition cylinder.
C.
Turn the ignition to ON (Just shy of starting car, Do NOT Start) then back to
OFF.
D.
Turn the ignition to ON (Just shy of starting car, Do NOT Start) then back to
OFF.
E.
Remove the key from the ignition.
6. Within 3 seconds the power door locks should cycle automatically indicating
successful entry into programming mode. Return to step 1 if the locks do not
cycle at this point, if they do cycle then continue to step 7.
7. Perform these steps within 40 seconds.
A.
Press the lock and unlock buttons on the remote simultaneously for 1 second.
B.
Immediately after letting go of the lock and unlock buttons, Press the lock
button by itself and hold for 2 seconds. Within 3 seconds the door locks should
cycle once indicating successful programming. If the door locks don't cycle or
cycle twice, repeat steps A and B, your remote has not been accepted.
C.
Repeat steps A and B in step 7 for each new transmitter.
8. Close driver�s door.
9. Test all remotes.
Lexus Keyfob 
